CXA001

I have several helicopters that I like to fly and want to use the hat switch on my joystick for certain keyboard commands, instead of POV (which is handled by the hat switch on my yoke). I have disabled all the POV for my hat switch in FSX controls for my joystick, however when when I add my key commands (that do work via the keyboard) nothing happens happens for left & right and up and down pans forward and backwards. Any assistance would be greatly appreciated.

That is correct. FSUIPC4 4.70(B) is what you need. This will allow all the gauges, etc. in your harrier jet to function properly with FSX.

Hi Pete, Tried configuring my Wilco Airbus aircraft as you suggested and it works like a charm! Thanks again for your assistance and your continuous contributions to the FS community. Kind regards,

Hi Pete, Thanks for the quick answer. Did not think about doing that as all my other aircraft are set to direct to calibration. I will give this a shot. Thanks for your help!

Hi all, Does anyone have a concrete solution on how to configure a Saitek Throttle Quandrant so that the throttles will work with FSUIPC with the Wilco airbuses? Thanks in advance,

Thanks Pete, Will enable some event logging and see what I can find. Kind Regards,

Yup v4.60

Ok perhaps I am not looking inthe right place but there is no Make NAV Freq increment=50Hz in the Misc tab in FSUIPC.

Make sure TCP port 8002 is open in your Windows Firewall.

I will give that a try. Thanks for your help! :)

Hi all, I have a couple of aircraft where when changing the heading, it changes in increments of 10 degrees. Apparently there is a setting in FSUIPC where you can change the increment, but I can't find it. I have searched this forum and looked at the documentation, but couldn't find anything. Any assistance would be appreciated.