Rotary switch of my Saitek switch panel used as a Autobrake switch (possible) !!!!

[Z feel free 7]

Hi pete, hope you well

I use the SPAD software to send each button click in my saitek switch panel to FSUIPC.

now I have all my saitek switch panel buttons are clickable inside the FSUIPC and I need to setting up the rotary switch as a autobrake switch (RTO OFF 1 2 & MAX).

Could I get the help to reaching what I need ?

note: the rotary switch in my saitek is 5 positions not 6.

Thanks a lot.

[Z feel free 7]

Hi

[spokes2112]

Pete is gone until september 7th. In the mean time take a look at "FSUIPC4 for Advanced Users" page 29, look for FSUIPC custom control 1007.

[Z feel free 7]

Pete is gone until september 7th. In the mean time take a look at "FSUIPC4 for Advanced Users" page 29, look for FSUIPC custom control 1007.

okay, thanks

[Pete Dowson]

now I have all my saitek switch panel buttons are clickable inside the FSUIPC and I need to setting up the rotary switch as a autobrake switch (RTO OFF 1 2 & MAX).

Could I get the help to reaching what I need ?

note: the rotary switch in my saitek is 5 positions not 6.

 

If the five positions are all seen by FSUIPC, or at least 4 "on" button states as well as an "off" state, then all you would need to do is assign them to the FSUIPC control  "Autobrake set" with the parameter set to 0 for RTO, 1 for off, and 2-5 for 1,2,3,MAX. You'd need to forgo one of those of course.

 

Pete