Rudder and Brake Axis not Recognized?

[TorranceR1]

Hi. I have been using FSUIPC for about a month now and have been very pleased with it. Although I have recently ran into a problem. I now have no control over my rudder and brake axis. I use saitek rudder pedals and therefore have a rudder and brake axis in the one controller. I tried to assign the rudder and brake axis through the Axis Assignment section of FSUIPC but every time I move either the rudder or brakes it is not picked up inside FSUIPC. I tried looking at saiteks own control panel for the pedals and everything seemed fine their, all axis working and moving in the calibration. I also tried assigning it in FSX's own controller page, it also worked their. I do not want to have it assigned in the FSX control settings though as I am on Windows 8 and have my controllers set up in their makes a lot of problems such as the controller just going off, that is one of the main reasons for me purchasing FSUIPC.

 

Any help is much appreciated as this is really annoying me and stopping me from flying at the moment.

 

Thanks, Robbie

[Pete Dowson]

I have seen recently folks use a utility to specifically assign joysticks to numerical IDs in the REgistry.  Look at this thread:

 

http://forum.simflig...ids#entry476819

 

Pete

[TorranceR1]

Thank you very much Pete. That has worked. Now I can get back to flying as normal! Again, thank you!

 

Robbie