Jump to content
The simFlight Network Forums

GF-TQ6 Flaps


Recommended Posts

I have tried to set up zones for my flaps and nothing works. If I set up "flaps" under axis assignment and then go to joystick calibration (6 of 11) and click the 'detent' button I get the 3 set buttons and in #1 zone the middle button shows '1'. When I try and move the flaps down to set the top of the zone and the bottom of the zone numbers do not change. I press the zone #2 button and it shows 16381 in the middle but again when pressing the 'set' button the zones dont change. And it is calibrated. When I go back to the sim the lever works but not until I moved past 50%. Any ideas?

 

 

Link to comment
Share on other sites

Hi,

 

You must do something completely wrong. I also have the GF-TQ6 and it perfectly works with all my planes. You should check, if you also have assigned the flaps axis in the simulator. Before assigning axis via FSUIPC be sure to clear all assignments in the sim. That's in most cases the error.

 

Rgds

Reinhard

Link to comment
Share on other sites

Yes I calibrated it windows and assigned it to flaps in fsuipc. I finally got flaps 1 and 5 assigned but when I try to assign 15 I click the center 'set' button and the number does not change like it does when assigning 1 and 5. Very confused as to what I am doing wrong.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.