FSUIPC Registration in a 2nd step

[BertrandM]

Hi everyone,
Switching to P3D v3 and I had to reinstall FSUIPC.
The registration process went wrong.
I selected both FSUIPC / Wide FS and Check existing registration.
The system turned me down - I should have probably selected Just enter new registration(s).
In Installing and Registering FSUIPC4.pdf, Peter Dowson states "You do not have to register at this time".
Fine, but what are the steps to do it later ?
I have my FSUIPC installed but not registered.
Can someone tell me how to access the installer for FSUIPC4 window to reinitiate a proper registration with my keys.

Thanks,
BertrandM

[Thomas Richter]

Hi,

if you didn't register at installation, just start FSX and open under Add-On the FSUIPC. On its first page that opens you will find on the right side registration buttons that will open the same panel as shown on the installation sequence.

You can also start the installation again without any harm and do the registration there.

Also make sure you use the latest installer Install FSUIPC4.959

Best practice as described in the installation manual is to copy and paste the details (name, email and key) instead of typing it in, gives very often error.

Thomas

 

[Pete Dowson]

On 12/21/2016 at 11:36 PM, BertrandM said:

Can someone tell me how to access the installer for FSUIPC4 window to reinitiate a proper registration with my keys.

Just run the Installer again. You can only register there, when it gives you that option.

There is a document about Installing and Registering included in the ZIP file. I strongly suggest you read that!

Pete