Elevator Trim Wheel Speed

[danewatson]

In MSFS2020 I have the Up and Down Elevator Trim bound to a button A1/A2 on my Saitek Yoke.

It all works very well but I was wondering if there is a setting (Parameter?) that would allow me to speed up the response of the trim wheel?

[John Dowson]

If you want larger trim increments/decrements (deltas) for each button press/release, you can assign to the trim offset 0x0BC0 using the offset sword increment/decrement controls, and give the inc/dec delta that works for you. If you are not sure how to do this, check the user guide and this forum - the same question has been asked many times before! For example, this post has detailed instructions on how to set this up:

 

John