Transfer from FSUIPC 6 to MSFS 7

[hrings]

Is there any posibility to load the FSUIPC 6 for so to reprogram them to fit the 7. Or do I have to program it new all over
I have a lot of switches spes. 737 overhead panel.

Bestreg.
HenningR

[John Dowson]

10 hours ago, hrings said:

Is there any posibility to load the FSUIPC 6 for so to reprogram them to fit the 7. Or do I have to program it new all over
I have a lot of switches spes. 737 overhead panel.

You can try using your FSUIPC6.ini file - just copy it to your FSUIPC7 installation folder and rename it to FSUiPC7.ini. Also, delete all of the settings under the [General] section and let that get rebuilt. You may need to keep some parameters (or set them again afterwards) if you have manually changed anything (such as profiles in separate files), but best to start with a clean [General] section.

If using the PMDG 737, then most, if not all, of the custom controls should be the same. However, the PMDG-specific offsets  have changed so you should check those if using them.
You may also want to revise the aircraft names in the profile section, if using profiles, as the aircraft names may not be the same. You can add MSFS aircraft to your profiles via the UI, but you may want to manually remove any P3D-specific aircraft.

John