Jump to content
The simFlight Network Forums

Assigning No Engine Reverse


Recommended Posts

Not sure why I can't seem to figure this out. I have looked in the manual and did a few searches here.

I just installed the F1 Cessna Mustang. It has no engine reverse. It has a Take Off detent, Climb detent, plus Idle and Cut-off. I have no problem calibrating the throttles for TO to Idle. However, I can't seem to figure out how NOT to have a Reverse range.

I need a full range of throttle so at maximum calibration range, the throttles are in TO, and at minimum range they are in Cutoff.

What am I overlooking?

Thanks.

PS: All the other a/c I have flown had engine reverse. I had no problems calibrating the axis for Max, Idle and Reverse.

Link to comment
Share on other sites

I just installed the F1 Cessna Mustang. It has no engine reverse. It has a Take Off detent, Climb detent, plus Idle and Cut-off. I have no problem calibrating the throttles for TO to Idle. However, I can't seem to figure out how NOT to have a Reverse range.

Is that a single engined aircraft? If so, use the normal single throttle.

If not, with the latest interim FSUIPC updates you can elect to have no reverse zone by checking the option for this top left. In previous releases it can be done too, by setting the idle zone with one value close to or the same as the minimum (the reverse setting), so that there's no reverse.

Pete

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. Guidelines Privacy Policy We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.