GoFlight GF-T8 only single state being recognized?

[RobAins]

I'm not sure if this is a FSUIPC issue or a GoFlight issue, but my GF-T8 switches are only being seen by FSUPIC as single state ... so they only work at a Toggle and not as an On and Off state?  I need an ON and OFF state/triggers.

 

Cheers, Rob.

 

 

[alaxus]

How did you configure it using the Goflight software? And what are you trying to interface?

[aua668]

Rob,

 

I have the GF-T8-II and I interface with them via FSUIPC (had this with FSX and now with P3D 2.4). And I see no problem. I get ON/OFF states/triggers. Maybe you check your EXE.XML. GF tends to add some programs here, which are not needed, if you communicate via FSUIPC only. Just set them to disabled in this file. Maybe these programs create some conflicts with FSUIPC. Just an idea and as a confirmation, that normally these devices are working fine with FSUIPC.

 

Rgds

Reinhard

[RobAins]

Thanks for the response ... FSUIPC is only showing a single event with my GF-T8 (original).  I have those switches disabled in GFConfig so they should not be conflicting with FSUIPC.

 

I'm going to try the GoFlight Interface Tool (polly-pot software - Steve's tool) and see what it shows for my GF-T8 (it's one of the very early GF-T8).

 

Cheers, Rob.

[Pete Dowson]

Thanks for the response ... FSUIPC is only showing a single event with my GF-T8 (original). 

 

That makes no sense. If FSUIPC was only detecting "on" and not "off", it would only ever detect it once and never again because it wouldn't see it "off"!

 

If you are referring only to the switches and buttons assignments tab, then, yes, that only shows the change from off to on because that's all it needs to do -- you assign both on and off actions then, on the same page.

 

Pete