RageOvSparta Posted May 13, 2017 Report Share Posted May 13, 2017 Is there any function to shorten when an aircraft turns to final if in the pattern or told to go around then enter the pattern? Because "close approved" or "enter left/right pattern" or "enter final" will take them to a 10-12 mile final.. which is silly and wouldn't happen unless instructed to. Is there a turn base leg now function to instruct an aircraft to turn inbound to the runway? Or a way to shorten their circle in the pattern to 3 or 4 miles. Link to comment Share on other sites More sharing options...
futureboy Posted May 13, 2017 Report Share Posted May 13, 2017 Unfortunately I have not found a way to do that. You can tell the plane to turn left/right ??? degrees, or turn left/right heading ???, but when you do that the state changes from state_pattern to state_flyaway and the only thing you can do is send the plane to departure. You could propose a change in the pattern to be 3nm instead of 12nm. I would not think this would take much except to have to wait for the next service pack. Unless the programming needs the 12nm to line up the plane for the runway. A longer wait would be a wishlist item for the next version to include an additional command to turn base leg now. RickyJ Link to comment Share on other sites More sharing options...
Sky King Posted May 14, 2017 Report Share Posted May 14, 2017 A "Short Approach" clearance would be nice as would a "Cleared for Immediate Takeoff" clearance. SK Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now