Tower!3DPro views during simulation

[ElPasoJoe]

Hello,

I am not able to look around from the tower. I am only able to click on aircraft in the strip and see the aircraft that I am communicating with. Any ideas how to look around the airport? This happens with all airports.

 

Thank you,

 

Joe

[ml0130]

You use the mouse wheel to look around 

 

[ElPasoJoe]

Thank you. I have also seen where people can zoom in or follow an aircraft. I'm not sure how this is done.

 

Thanks again,

 

Joe

[DeltaVII]

You follow the aircraft by clicking on it's tag in ADIRS or it's strip, and you zoom in or out using the mouse wheel when the aircraft is not selected (use the CLEAR button in the command panel).

[Avwriter]

I think perhaps you may have misunderstood that to pan around you need to click and hold on the mouse wheel down (assuming that your mouse wheel is clickable) and then pan by moving the mouse.

 

Andrew

 

[ElPasoJoe]

Thanks everyone. I did figure out about holding down the mouse. I have seen some videos that are not in Multiplayer mode where you can go to an aircraft or change viewpoint within the game. This is mainly what I am wanting to know. Thanks again

[hexzed]

There is the "action camera" which is the camera icon in the control panel. If you select this it will zoom in and give you different views depending on which trigger points it is hitting.

Normally this is takeoff, and pre selected taxi points. At JFK you get landing camera, but this doesnt seem to work anywhere else 😥